Latest activity

What's new Featured content New posts Latest activity
  • sam2019
    sam2019 reacted to Dool's post in the thread DUM DUM BULLET with Like Like.
    Base line today! It will, hopefully, be way South of the 25.6RWHP recorded last week :unsure:
  • sam2019
    sam2019 reacted to Dool's post in the thread Low End Engine Noise with Like Like.
    Dealers with the diagnostic tool can reset IAC. 15mins may not be enough to get to operating temperature, I do 25 to 30mins and use an...
  • sam2019
    sam2019 reacted to J.B.'s post in the thread Low End Engine Noise with Like Like.
    Only 3k! Im the 3rd owner already.... may be a lemon. I was so excited to buy it I didnt do a great pre inspection before purchase... I...
  • sam2019
    sam2019 replied to the thread DUM DUM BULLET.
    Who needs a rear brake really ...
  • sam2019
    sam2019 replied to the thread Low End Engine Noise.
    Only 3k miles? has it been sitting a long time without movement in old oil (acid in oil can damage bearings). Any service history...
  • sam2019
    sam2019 replied to the thread Well another happy customer....
    M6 × 0.75 → fine thread, 0.75 mm between threads Thread pitch is a key measurement that describes how "coarse" or "fine" a screw thread...
  • sam2019
    sam2019 reacted to Dool's post in the thread DUM DUM BULLET with Like Like.
    Because the stock muffler is made the way it is, it doesn't take a sniffer tube at the Dyno shop meaning I will not be getting fueling...
  • sam2019
    sam2019 reacted to Mattman's post in the thread J-Engine 500cc Thread with Love Love.
    All of my product arrived today, with no extra charges! Well done I now have plenty of spares for the future in case I decide to open...
  • sam2019
    sam2019 reacted to PieMon's post in the thread ODBII scanning BS4 and BS6 with Like Like.
    Thank you, found it - it was burried deep and not visible from the top by the previous owner or factory. I now ordered cable, Bluetooth...
  • sam2019
    sam2019 replied to the thread Helping the 411 Hima and Scram to brake even :-).
    Even in India the 440 is a rare bird, I will have to do some research if other models use the same caliper as is often the case with...
  • sam2019
    sam2019 replied to the thread Helping the 411 Hima and Scram to brake even :-).
    well, considering I had 5 Himas and all had lousy stock brakes (until I changed them) I think I can judge the improvement with the 440...
  • sam2019
    sam2019 replied to the thread ODBII scanning BS4 and BS6.
    No, the workshop needs the same plug for their diag instrument so all you need to do is visit a RE showroom and ask them to read out...
  • sam2019
    sam2019 replied to the thread Dyno tested..
    going back to car driving :-) ?
  • sam2019
    sam2019 reacted to Dool's post in the thread Dyno tested. with Like Like.
    Tomorrow I return to the Dyno that all my Himalayan runs/Mods/Improvements were done. This time its being done backwards ( again) run...
  • sam2019
    sam2019 reacted to pauli's post in the thread J-Engine 410cc Thread with Like Like.
    Yes, I have the cam lock, crank lock, right cover gasket etc. The bike is partially stripped waiting so the tank, exhaust and coils are...
Show older items
Back
Top