OK guys, if you look at these images, how can I (where on the unit and what to buy/do) adjust resistance (I believe) in order to make my fuel gauge in my aftermaket speedo read the fuel level properly?
Current speedo has a setting for 100, 250 and 1200 which I guess has to do with tanks capacity. If I set it at 100 the bars on the display dissapear after a few km, if I leave it at 250 (omhs I guess it is) it stops counting bars after 4 bars which represents about half a tank.
So my basic understanding takes me to add an extra resistor somewhere in the unit or I was thinking I could just bend the buoy a bit just as you use to do in old toilet system in order to make read stock resistance a bit better.
Current speedo has a setting for 100, 250 and 1200 which I guess has to do with tanks capacity. If I set it at 100 the bars on the display dissapear after a few km, if I leave it at 250 (omhs I guess it is) it stops counting bars after 4 bars which represents about half a tank.
So my basic understanding takes me to add an extra resistor somewhere in the unit or I was thinking I could just bend the buoy a bit just as you use to do in old toilet system in order to make read stock resistance a bit better.
Last edited: